

#Navigation in CellMICROCOSMOS  (since 3.1rev)

##Basics

In order to navigate through the visualized cell in CellMICROCOSMOS,
the user may move a virtual camera around. The camera is characterized
by viewing position and direction, as well as a focal length (zoom
factor). Each of these can be modified through user input on mouse 
and keyboard. Controls were designed in a way, that either sole mouse 
OR sole keyboard are sufficient, albeit simultaneous use of both is 
highly recommended.

##Camera Manipulation

For version 3.1rev, the navigational concept and the control commands
via the mentioned devices were completely revised. Especially the arrow
keys, as well as [W],[A],[S],[D] are used for camera manipulation. 
They are often used in combination with [CTRL]. 
The precise action that is associated with these inputs, depends on 
the active navigation mode. There are currently three different modes
to distinguish. 

Floating mode is the initial state after launch. The cursor is free to
move around on screen for interaction with nodes and components. The
camera is moved and turned around in the local (camera) coordinate 
system. This movement is independent from any object in the cell.
Floating mode is kind of an initial mode from where to switch into 
and from one of the two other more specialized modes.

Holding down [SHIFT] or activating [CAPS-LOCK] enables flight mode.
This mode is very similar to floating mode, as it moves the camera
vessel-like in the local coordinate system. The key difference is the
fact, that the cursor is locked in the middle of the 3D-View. Although
this makes a GUI-interaction impossible, it enables a more intuitive
navigation, as the camera can be turned around with the mouse.

If there is a picked object, the user can bind to it and switch to 
object bound mode. In this mode, there is a specific object, the
camera moves around. The user can no more navigate in camera local
coordinates but moves along longitude and altitude of the bound
object. Height above the object and tilt from the perpendicular 
vector can be manipulated.

Camera view may be reset via context menu or pressing [h].


##Picking

Interaction with cell components or pathway nodes is triggered via 
mouse or the left-click-counterpart [SPACE]. On press of left mouse 
button or [SPACE]-down, picking is activated. In this state, the user
can select one of the objects under the cursor using the mouse wheel
or [+],[-] keys. On release of either space or left mouse button, the
selected object is picked. Picking an object displays information about
it in the info panel and makes it usable for object bound mode.

While picking, usually the nearest object is preselected. If the former
picked object is a node and this node happens to be under the cursor,
it is preferred over the nearest component. This makes it easier to 
bring up the context menu for a node, as they are often behind bigger
cell components, as a right click on a former picked node will bring
up its context menu and not the one of the closer component.



##Zoom

Focal lenght can be changed via [+],[-] or mouse wheel (when picking
is not active). Zoom may be reset to the original setting via context
menu or [r].

